TE EZ MOD Install Notes: Jumpers and Slider Switches!

The TE EZ MOD is a rather painless install. There are a couple minor tweaks you need to do though.

  1. Cut the SJ2 or SJ3 jumper with an exacto-knife depending on your home panel situation. See the graphic below for which to cut.
  2. Trim the actuators on the slide switches with some flush cut snips. You only need to trim a small amount so the covers fit on it and allow the PCB to screw down properly. Sneak up on the cut carefully!

About Author

Get In Touch

Products

Recent News

Bulk Shipping Status

I’m sure you read the Shipping Information Page and understand that orders get consolidated (after packing and labeling) and shipped to the US to minimize the number of individual packages being sent on a daily basis. Here’s the status of those larger boxes:

Shipping Information and Timelines

Yes, this was displayed boldly on the website when you placed your order. This single post can and will answer about 99.9% of the questions regarding shipping, so I wanted to keep it readily available so that I could refer back to it when I inevitably get a couple hundred questions about shipping status…

Panzer Fight Stick History
Panzer Fight Stick

The Panzer Fight Stick History

I didn’t start making Fight Sticks with the intention of turning it into a business. In 2012 I built a

%d bloggers like this: