Panzer Fight Stick 3 – Electrical – Can I use the Brook PS4+ with Audio Board in the Panzer Fight Stick 3?


The short answer is: it depends on your modding skill level and willingness to do a little extra work. In the image below I highlight the differences in pin location between the boards. Because the EZ BUILD system was designed around the Universal Fighting Board and Brook thought it would be a good idea to move everything around on the PS4+ with Audio Board (they didn’t consult any vendors on this design), they aren’t pin for pin compatible.

PS4AudioBoard.png

The PS4+ with Audio Board has all of the pins pre-soldered as unlock-able, non-shrouded pins. This means that only friction is holding the wire housings to the pins. This is unsafe as I know that over time the cables will work themselves loose from the constant banging and moving of the Fight Stick. The EZ BUILD system includes connectors that are meant to be locked into place with their matching housings and designed for the placement on the Universal Fighting Board.

Next you will notice that the RS/DP/LS switch location is on opposite sides of the PCBs (highlighted in ORANGE). The included cable with the EZ BUILD may not reach that far an look clean when done.

Finally, you will see that the TP CLICK, R3, and L3 are on their own pin headers on the PS4+ board and vastly different than the common 4 pin header on the UFB. To adapt, you would need a cable to go to 2 locations from the EZ BUILD board instead of just one and it would be required be made longer.

IF I were to install this into a PFS3 I would do the following:

  • Use the included cables from the EZ MOD and clip one end of the connector of (the one that connects to the UFB).
  • Lengthen each wire as required to reach the locations on the PS4+ board.
  • Solder them to the UNDERSIDE of the PS4+ board in the proper pin locations. 

About Author

Get In Touch

Products

Recent News

Bulk Shipping Status

I’m sure you read the Shipping Information Page and understand that orders get consolidated (after packing and labeling) and shipped to the US to minimize the number of individual packages being sent on a daily basis. Here’s the status of those larger boxes:

Shipping Information and Timelines

Yes, this was displayed boldly on the website when you placed your order. This single post can and will answer about 99.9% of the questions regarding shipping, so I wanted to keep it readily available so that I could refer back to it when I inevitably get a couple hundred questions about shipping status…

CPS1 Cases in the Wild!

The CPS1 case launch has been a wild ride. Development all the way to delivery has been stressful and enjoyable

%d bloggers like this: